ZANKER KAM961 Notice D'utilisation page 8

Connecting the appliance to the
power supply
8
(A)
• the electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. or it
should be possible to isolate the oven
from the supply by incorporating a switch
in the fixed wiring in accordance with the
wiring rules.
• the power supply cord may only be
replaced by an electrician.
• if the supply cord is damaged it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
• the socket should not be positioned
behind the cupboard.
• the best position is above the cupboard,
see (a).
• Connect the appliance to a single phase
220-240 V/50 Hz alternating current via a
correctly installed earth socket. the
socket must be fused with a 10 a fuse.
• Before installing, tie a piece of string to
the power supply cord to facilitate
connection to point (a) when the
appliance is being installed.
• When inserting the appliance into the
high-sided cupboard, Do not crush the
power supply cord.
• Do not immerse the power supply cord
or plug in water or any other liquid.
• Do not allow the power supply cord to
run over any hot or sharp surfaces, such
as the hot air vent area at the top rear of
the oven.