Publicité
Les langues disponibles
Les langues disponibles
9. Attaching the Belt Clip
Follow the instructions below to attach the included belt
clip to the transmitter.
1. Align the belt clip to the grooves on the back of the
transmitter.
2. With a firm grip, screw on the belt clip's Phillips head
screws with a screwdriver.
Caution!
Tighten until firmly in place. Be careful not to over
tighten.
20
10. Using the Test Light
1. Turn on the receiver by touching the magnetic red dot
on the back of the transmitter to the red dot on the
receiver. The indicator light will come on for a moment
then blink once every 4 seconds, showing that the
receiver is ready to use.
2. Turn the transmitter on by holding down the on/off
button on the right side of the transmitter. The LED will
blink every 4 seconds and the LCD screen will show the
remaining battery life.
3. Place the test light, included in the package contents,
on the contact points as shown in the diagram.
4. Watch the test light as you press the Nick button on the
transmitter. It should light up for just a moment. The
higher the intensity, the brighter the test light will be.
5. Watch the test light as you press the Constant button on
the transmitter. It should light up as long as the button
is pressed. However, as a safety feature, the receiver
will automatically stop the stimulation if the Constant
button is pressed for 12 seconds or longer.
21
Publicité
