Before Sitting; After Use; Fault Finding - BH TECNOVITA Milan M900 Instructions De Montage Et Utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
• OPERATION
Start up
Plug the machine into the mains supply.
Set the switch to ON

Before sitting

Before sitting, make sure that the footrest is attached correctly to the chair frame.
Make sure that all of the components are in the default position. If not, switch the chair
on again to reset all of the positions.
WARNING
Do not sit on the chair with the footrest hanging.
To avoid damaging the footrest, do not suddenly drop full body weight on to it.

After use

After use, switch the chair off and unplug it from the mains supply.
To protect children from accidents and injuries, always make sure that the chair has been unplugged from the
electrical mains socket.
If the chair is not going to be used for prolonged periods, store it away.
How to store it:
First place the footrest into its lowest position, Fig.A, and the backrest fully up, Fig.A.

FAULT FINDING

Problem
Rasping sound during use
It does not operate
The music does not play
correctly
The sound is echoed when
you press the music key.
No sound from earphones
It is not possible to raise or
lower the backrest or
footrest
It is not possible to extend
the footrest normally.
If the above solutions do not solve the problem, switch the chair off and unplug it from the wall socket, then get in
touch with your Technical Assistance Service or local retailer, who will remedy the fault.
Check the following
This is due to the construction of the chair or
friction between the massage rollers and the
leather upholstery,
Is it plugged into the electrical wall socket
It is switched off
The fuse has blown
The music is not MP3 format
The disc has not been inserted correctly
The disc is still going through the start-up
sequence
Incompatible music format
Make sure the earphones are plugged in.
Volume is too low or switched off
Is the backrest or footrest overloaded
The footrest is too close to the floor, which is
activating the floor proximity sensor.
32
Fig.A
Solution
Normal sound
Plug it in.
Switch it on
Replace the fuse with a
similar type
Change music format
Reinsert the disc
Wait 5-10 seconds before
selecting any music
The computer is checking
the MP3 files
Change the earphones.
Increase the volume
Reduce the load or pressure
on the backrest or footrest.
Place the footrest in a higher
position.

Publicité

Table des Matières
loading

Table des Matières