BH TECNOVITA Milan M900 Instructions De Montage Et Utilisation page 24

Step 3: Fig.3
Fitting the side panels.-
Carefully move the armrests out of the way to
prevent scratching during installation.
1) Attach the side panels to the seat frame using
the two Z-hooks Fig.3.
2) Connect the air pipes for the armrests (M)
and (N), paying attention to coloured labels for
the different pipes.
Make sure that the air pipes are not forced on.
3) Insert the holding screw (P) (for the side
panel) into the hole (O) (on the seat frame), fit
the plain washer and the spring washer and
tighten using the M-6 nut to secure the side
panels.
Step 5: Fig.4
Insert the rotation shafts (R and S) for the armrests,
Fig.4.
Once the shafts are joined (T), fit them into the backrest.
Step 6: Fig.5
Attach the remote control support (1) to the panel using four screws,
Fig.5.
Attach the remote control support at the top of the support using
screws (2).
24