3.2.10
W
. High pressure may cause parts to rebound: wear all the protective
arning
clothing (PPE) and equipment needed to ensure the operator's safety.
3.2.11 W
. Before doing work on the machine, REMOVE the plug.
arning
3.2.12 W
. Before pressing the trigger, GRIP the trigger gun firmly to counteract
arning
the recoil.
3.2.13 W
. COMPLY WITH the local water supply authority regulations. Under
arning
IEC 60335-2-79, the machine may only be connected to the mains drinking
water supply if the supply hose is fitted with a backflow preventer valve with
drain facility corresponding to EN 12729 type BA. The backflow preventer valve
may be ordered from the manufacturer.
3.2.14 W
. Water that has passed through backflow preventers is considered to
arning
be non-potable.
3.2.15 W
. Maintenance and/or repair of electrical components MUST be carried
arning
out by qualified staff.
3.2.16 W
. DISCHARGE residual pressure before disconnecting the hose from the
arning
machine.
3.2.17 W
. CHECK before each use and at regular intervals that the screws are fully
arning
tightened and that there are no broken or worn parts.
3.2.18 W
. ONLY USE detergents which will not corrode the coating materials of
arning
the high pressure hose / power cable.
3.2.19 W
. KEEP people or animals at least 15 m away.
arning
3.2.20 W
. This machine is designed for use with the detergents supplied or
arning
recommended by the manufacturer. The use of other detergents or chemicals
may adversely affect the machine's safety.
3.2.21 W
. Do not allow the detergent to come into contact with the skin, and the
arning
eyes in particular! In case of contact with eyes, rinse with plenty of water and
seek medical advice at once!
3.2.22 W
. High pressure hoses, fittings and joints are important for the machine's
arning
safety. Use only high pressure hoses, fittings and joints recommended by the
manufacturer.
3.2.23 W
. To ensure the machine's safety, only use the manufacturer's genuine
arning
parts, or other parts which carry its approval.
English
11