Blue Clean 7850 Traduction Des Instructions Originales page 10

10 English
3.1.20 W
arning
3.1.21 W
arning
components, the high pressure jet is potentially dangerous. Do not use the
rotary nozzle kit, and always keep the jet at a distance of at least 30 cm during
cleaning.
3.1.22 W
arning
specifically intended for the model in question is prohibited. All modifications
to the machine are prohibited; any modifications shall render the Declaration of
Conformity null and void and relieve the manufacturer of all liability under civil
and criminal law.
3.1.23 W
arning
the machine.
3.1.24 W
arning
hazard.
3.2 SAFETY "MUSTS"
3.2.1 W
arning
3.2.2 W
arning
and comply with IEC 60364-1. Either a residual current device that will cut off the
power supply to this machine if the leakage current to earth exceeds 30 mA for
30 ms or a ground fault interrupt device must be installed.
3.2.3 W
arning
3.2.4 W
arning
the operator (30 mA).
3.2.5 W
arning
3.2.6 W
arning
cross-section.
3.2.7 W
arning
3.2.8 W
arning
Inhalation of aerosols can be hazardous to health.
3.2.9 W
arning
necessary protective measures regarding aerosols, depending on the surface to
be cleaned and its environment. Respiratory masks of class FFP 2, an equivalent
or higher are suitable for the protection against hydrous aerosols.
. DO NOT move the machine by pulling on the high pressure hose.
. When directed towards tyres, tyre valves or other pressurised
. The use of non-original accessories and any other accessories not
. DO NOT use unsuitable diesels as this may be hazardous or damage
. DO NOT touch the boiler or the exhausts during operation. Burning
. All electrical conductors MUST BE PROTECTED against the water jet.
. The electric supply connection must be made by a qualified electrician
. DURING start-up, the machine may cause network noise.
. Use of a residual current device will provide additional protection for
. Models supplied without plug must be installed by qualified staff.
. Use only approved electrical extension leads with suitable conductor
. Always turn off the switch when leaving the machine unattended.
. During use of high pressure washers, aerosols may be formed.
. The operator shall perform a risk assessment in order to specify the