Presetting Dab Services Automatically; Btm; Presetting Dab Services Manually; Preset Edit - Sony CDX-CA850 Mode D'emploi

Presetting DAB services
automatically

— BTM

The BTM (Best Tuning Memory) function picks
out DAB ensembles and automatically assigns
the services within the ensembles to preset
service numbers. The unit can preset up to 40
services.
If services have been previously set, the BTM
function operates under the following conditions:
• If you activate the BTM function while
listening to a preset service, the unit will store
detected services (by overwriting) only to
preset numbers higher than that of the current
present service.
• If you activate the function while listening to a
service that is not preset, the unit will replace
the contents of all preset numbers.
• In both cases above, if the unit detects a service
that is identical to one already preset, the
previously stored service remains unchanged
and the newly detected service is not preset.
1
While listening to a DAB programme,
press (MENU).
2
Press either side of (DISC) repeatedly
until "BTM" appears.
3
Press (ENTER).
A beep sounds when the service is stored.
After activating the BTM function, the unit
tunes the service assigned in the preset
memory 1 automatically.
Note
If the unit can only tune in a few services, the BTM
function may not assign services to all the preset
service numbers.
Presetting DAB services
manually

— Preset Edit

You can also preset DAB services manually or
delete a service which is already preset. Note that
up to 40 services (preset either by the BTM
function or manually) can be preset to the unit's
memory.
1
While listening to a DAB programme,
press (MENU).
2
Press either side of (DISC) repeatedly
until "PRS Edit" appears, then press
(ENTER).
3
Select the service and the preset
number you want to preset.
1 Press either side of (SEEK) to select
the service.
2 Press either side of (DISC) to select
the preset number.
3 Press (ENTER).
The Preset Edit commands will appear in
the display.
4
Press either side of (DISC) to select
the desired command.
5
Press (ENTER).
To edit other services, repeat steps 3 and 4.
continue to next page t
21