Publicité
Les langues disponibles
Les langues disponibles
8.
When the preheating is done, the light will turn green. The water pump will
start working and you will start to see steam start to come out of the mop
head.
9.
Push and glide the mop over the floor surface to clean it. Try to use up all
the water in the tank at one time. Do not use the mop just in one place, or on
the same place over and over again. Depending on the material of the floor,
it may deform or fade it over time. If there is any water left in the water tank,
empty the remaining.
10. After you have finished mopping, press the power button to switch the mop
off.
11. Unplug the power cable from the mains outlet socket and wind it around the
cable management hooks to secure in place.
Before cleaning, turn off the steam mop and allow it to cool down completely.
To clean the main unit, use a dry cloth to remove any dust or dirt. If there are
stubborn areas of dirt, use a damp well-wrung cloth to wipe over the body.
Leave to air dry or use a dry cloth afterwards to dry it.
Important:
•
Do not immerse the power cable, plug or the mop itself into water or
any liquid.
•
Do not pour water or any liquid over the mop.
•
Do not use detergents, abrasive cleaning products or any kind of
cleaning solutions in the water tank as this may damage the mop.
•
Do not use alcohol or solvent-based cleaners on the plastic
components, as this will cause the cracking and ageing of these parts.
How to Use (Continued)
Cleaning and Maintenance
11
Publicité
