Sharp CD-BK270W Mode D'emploi page 25

Playing Karaoke
1
To protect the speakers from shock noise and to avoid disturbing
noises, set the MIC LEVEL control to MIN.
2
Connect the microphone to the MIC socket.
z Use a microphone with a 6.3 mm (1/4") plug, an impedance of 600 ohms.
z If a microphone whose sensitivity is too high is used, howling may be gener-
ated.
z Unidirectional microphone is more appropriate for vocal use.
z Use a standard plug adaptor when using a microphone with a 3.5 mm (1/8")
diameter plug.
3
Press the ON/STAND-BY button to turn the power on.
4
Press one of the CD, TUNER (BAND), TAPE (1
buttons to select the audio source and play it.
If you wish to record, start recording in the TAPE 2 compartment. (Refer to pages
26 - 28 for details.)
5
Adjust the volume of the audio source using the VOLUME buttons.
6
Rotate the MIC LEVEL control towards MAX to increase the micro-
phone volume and towards MIN to decrease the microphone vol-
ume.
7
Press the ECHO LEVEL button on the remote control to increase
the microphone echo, and the ECHO LEVEL
the microphone echo.
Note:
When excessively loud signals enter the microphone, your voice may be distorted
depending on the devices connected. If this happens, lower the microphone volume.
If squealing occurs:
z Reduce the microphone volume.
z Change the direction that the microphone faces.
z Reduce the volume of the main unit.
z Move the microphone away from the speaker.
Caution:
z When not using the microphone, remove the microphone plug from the MIC
socket.
z When connecting or disconnecting the microphone plug, set the MIC LEVEL con-
trol to MIN.
2), VIDEO/AUX
button to decrease
ENGLISH E-24