Publicité
Les langues disponibles
Les langues disponibles
EN
Recessed magnet
Edge and corner operating sketch
Fig. 3
Step 4: As shown in figure 4, once you stop working, remove your hands from the handle
and let the machine stay where it is for 30 seconds. Afterwards, press the motor power
button after the dust inside of the anti-dust cover has been properly collected and
cleaned.
Y type wrench
Remove the cup wheel
Socket head wrench
Install the cup wheel
4
Step 3: As shown in figure 3, remove the front anti-dust cover board from the anti-dust cover
towards the direction shown by the arrow, in order to expose the diamond cup wheel for corner
grinding demand. Afterwards, repeat step 2, the machine is ready to operate as soon as it becomes
stable.
Fig. 4
Step 5: As shown in figure 5, for replacing the cup wheel, you should first remove the old cup
wheel by following these steps:
1) Put both ends of the Y type wrench into the holes around the edge of the diamond pad.
2) Fasten the hexagonal wrench to the lock screw.
3) Rotate both the wrenches towards opposite directions.
4) Take the lock screw off.
Installing a new cup wheel is easy provided you repeat the above steps.
Fig. 5
WWW.NIKOLAOUTOOLS.GR
Let the machine stay where it is for 30 seconds, and then press the
motor power button
Publicité
