ThermoPro TP-22 Mode D'emploi page 3

Transmitter Features
ºF/ºC/
LCD (Liquid Crystal Display) – displays temperatures of both probe 1 and probe
2. It will automatically switch between probe 1 and probe 2 displays.
Wire Stand – Allows you to stand the transmitter on tabletop or it can be reversed
and used as a hanger.
Battery Compartment – holds 2 AAA batteries.
Sensor socket hole – Plug-in for stainless steel probe 1 and probe 2.
Button
ºF/ºC / – Press once to turn on or off the transmitter. Press and hold for 2 seconds
to select the transmitter temperature display in ºC or ºF.
Installing batteries
Open the battery compartment of the receiver and insert two "AAA" batteries with
correct polarity. Open the battery compartment of the transmitter and insert two
"AAA" batteries with correct polarity.
Turn On/Off Unit
Press button on the receiver to turn on/off the receiver;
Press ºF/ºC / button on the transmitter to turn on/off the transmitter.
WIRE STAND
-4-
Synchronize/Pair Transmitter and Receiver
The transmitter and receiver were already paired at our manufacturing facility.
Usually you do NOT need to re-synchronize or re-pair the units. You just plug in
the probes, insert batteries, turn on the receiver and the transmitter and wait for a
few seconds, you will see the temperatures shown on both receiver and transmitter
and the units are ready for use.
However, in some unusual cases, the transmitter and receiver are no longer paired,
then you may need to re-synchronize them by following the below steps:
a. Insert the stainless steel probes into the corresponding plugs in the transmitter.
b. Turn on the transmitter by pressing the ºF/ºC
the current temperatures on its LCD display.
c. Turn on the receiver by pressing the
d. Press and hold Mode button on receiver for 2~3 seconds to enter the synchronization
mode which will last for 60 seconds. The display shows "---" and it is flashing.
e. Wait for a moment until the temperature reading shows on the receiver display,
it means the synchronization/Pairing is complete. Your professional remote
cooking thermometer is now ready for use.
Note: The synchronization between the transmitter and the receiver won't be lost
even if you replace the batteries.
Loss link alert
If the receiver is taken out of range or there is abnormal external interference or
after shutting off the transmitter, the receiver may not be able to receive the
transmission from the transmitter. If this happens for over 4 minutes, the unit will
alert you the signal is lost. Pressing any button on Receiver will stop the Loss Link
beep.
To regain transmission signal, move the receiver closer to the transmitter, the link
should be automatically restored and the temperatures should appear on the
receiver display.
/ button. The transmitter will show
button.
-5-
-5-