Error Messages; Error Description - Texinov FLUXMEDICARE V2 Manuel D'utilisation

5. Error messages

Error Description

E1
E2
E3
E4
E5
E6
If the light source overheats, the rearmable thermal circuit breaker will cut the power supply for the Medical
Device automatically. The treatment in progress must be restarted. The Medical Device cannot restart whilst
the system is not at nominal operating temperature (see 3 .5). The user must ensure that the ventilation is not
obstructed. No action is necessary.
User Manual for the FLUXMEDICARE® V2 System - IFU-FLUXMEDV2 - V.1.1 – 03/2021
TEXTLIGHT6-V2
Bilateral temple sheath
Action required
Contact MDB TEXINOV to obtain new luminous bands.
Connect the luminous band ferrules to the intermediate unit
of the source and press the "START/PAUSE" button. While
the laser is not reconnected, the red warning light is on. In
the event of accidental disconnection during treatment, a
sound signal is heard in addition to the illuminated red
warning light.
Stop the source and wait until it cools. Check that the air
openings are not obstructed and that the ambient
temperature does not exceed the nominal values. If the
problem persists contact Technical Support. When starting
next the appliance will display an error. A diagnosis will be
performed.
Stop the source and restart it.
If the problem persists contact Technical Support.
When starting next the appliance will display an error.
The count key is not connected. Connect the count key and
press "START/PAUSE". While the key is not reconnected a
sound signal is heard and the red warning light is on.
The count key is not the one that was connected at the start
of treatment. Reconnect the count key used initially and
press "START/PAUSE". While the initial key is not
reconnected a sound signal is heard and the red warning
light is on.
If the screen does not turn on or does not display anything
do not use the source.
Contact MDB Texinov
A diagnosis will be performed.
Page 51 / 84