De Dietrich DPI7682X Guide D'utilisation page 28

2
•
USE
Power Management
Model only
Available power levels:
Hob power Cooking
in kW zone
16 cm
7,4 2000 W
4,6 2000 W
3,6 2000 W
3 2000 W
When several cooking zones are
used at the same time, the hob manages
the power distribution, so as not to
exceed its total power.
When you use maximum power (Boost)
on several cooking zones at the same
time, position pans to achieve the best
positioning and avoid arrangements
(2.3.1 - 2.3.2 - 2.3.3 - 2.3.4 - 2.3.5.)
2.4 SWITCHING ON/OFF
Press the On/Off key
in each zone for 8 seconds (2.4.1). If
no pan is detected, select a zoner
(2.4.2). If a pan is detected, the «0»
flashes with a dot. You can then set the
power level. The cooking area heats up
automatically.
Switching off a zone on the hob
Press and hold the key for zone
long beep sounds and the display goes
off or an "H" appears (residual heat).
Press the On/Off key to switch the hob
off completely.
Cooking Cooking
zone zone
18 cm 23 cm
2800 W 3100 W
2550 W 2800 W
2400 W 2600 W
2100 W 2200 W
a
. "0" flashes
c
, a
2.5 SETTING THE POWER
Press the + or –
numeric keypad
power level between 1 and 19 or 1 and
Power Management
14 (model
enter the number corresponding the
desired power setting directly (2.5.2).
Pressing the «0» key switches the hob
off.
When switching on, you can go directly
to maximum power (apart from boost)
by pressing the "–" key for the zone.e .
Power presets
There are four
provide direct access to pre-set power
levels:
= power 2 - Keep warm
= power 10 - Simmer
= power 19 - Sear
BOOST = maximum power (2.5.3)
These power values can be modified,
except for BOOST.
Proceed as follows:
The hob must be switched off.
- Press and hold
to select it.
- Set the new power setting by pressing
on the + or - button.
- A beep will confirm your action after a
few moments.
Note: Power levels must be between
1 and 3 for
4 and 11 for
12 and 19 for
For model
are as follows:
= power 2 - Keep warm
= power 8 - Simmer
= power 14 - Sear
27
g
key (2.5.1) or use
o
to adjust your
). In this case you can
f
keys available that
or or
the pre-set power level