Buffalo FB865 Mode D'emploi page 5

• Buffalo recommends that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Testing.
• Buffalo recommend that this product is connected to a circuit
protected by an appropriate RCD (Residual Current Device).
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.
Pack Contents
The following is included:
• Microwave Oven
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Installation
1. Remove all packaging materials. Make sure that all protective plastic film and coatings are thoroughly
removed from all surfaces.
Warning: Check for any of the following damage that may have occurred:
• Misaligned or bent door, damaged door seals/sealing surface, broken/loose
door hinges, dents in the oven interior.
• DO NOT operate the oven if any damage is found. Call a BUFFALO agent or
qualified Technician.
2. Position the oven on a flat, stable and heat-
resistant surface. For sufficient ventilation,
allow a minimum of 30cm of space above the
oven, 10cm at the back and right side. The left
side must be open.
Note: Do not cover or block any
openings on the appliance, or
remove the feet.
3. Place the oven as far away from radios and
TV as possible as operation of the appliance
may cause interference to your radio or TV
reception.
FB865_FE143-E_ML_A5_v3_20240703.indb 5 FB865_FE143-E_ML_A5_v3_20240703.indb 5
• Instruction manual
30cm
EN
5
2024/7/3 13:35 2024/7/3 13:35