Buffalo FB865 Mode D'emploi page 15

14. "CLEAN FILTER" reminding function
1. If User Option OP:01 is selected and the set time expires, the oven will remind the user to clean the
filter.
• Note: The oven must be powered up.
2. The display will show "CLEAN FILTER". At this time, pressing
the oven into Ready Mode.
3. If not desired to clean the filter, just press
reminder information. Otherwise, the oven will keep reminding constantly during Idle Mode.
15. User Option Mode
This allows the user to choose between various ways for the oven to operate.
1. Open the door and press "2" for 5 seconds to enter User option mode.
2. The display shows "OP: - -".
3. Press any number button to enter related mode setting.
• For example: Setting the voice of the buzzer to medium. Press "2", "23" is shown. If you want to
change, keep pressing "2", the display will show "OP:20", "OP:21", "OP:22", "OP:23", "OP:20".....in
cycle.
4. Press to save the current setting. After saved, "OP: - -" is displayed again.
Notes:
• During setting, press
• If button not pressed at the last step, the program cannot be saved but returns to previous
state.
16. Factory-default setting
In ready mode, press
display will show "CHECK".
• If it is in the factory default setting, the display will show "11".
• If NOT in the factory default setting, the display will show "00".
• If desired to restore the default setting, press
"CHECK" and finally "11" . Now the factory-default settings are restored.
Note: Be careful of the operations as it will restore all the factory-default settings.
Note: Should the restoration of default settings fail, please just repeat above operations.
FB865_FE143-E_ML_A5_v3_20240703.indb 15 FB865_FE143-E_ML_A5_v3_20240703.indb 15
button and hold for 3 seconds to clear out the
to enter Door Open Mode. Close the door to enter Ready Mode.
and "0" to check the factory-default setting. The buzzer sounds once and the
button or opening the door will put
again. The display will show "CLEAR" first, then
EN
15
2024/7/3 13:35 2024/7/3 13:35