Télécharger Imprimer la page

Warm Tech WTCHM2000TL Traduction Des Instructions D'origine page 22

Radiateur ceramique-mural

Publicité

Les langues disponibles

Les langues disponibles

OPERATION INSTRUCTIONS
1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in your
area matches that on the rating label on the unit.
2. Carefully remove the heater from the plastic bag and the carton.
3. Place the heater on the wall ,setting the master button to "-"position.plug the cord set into a
AC220-240V~ electrical outlet,with "BEE" sounds the "Power"light is on with RED color and
the heater will shows the default temperature ,it will twinkle 3 seconds.
1) HEATING PERPARE
Set time
Before turn on the heater,set the time as right time.Press remote control "
control panel,it shows
lights on,press "
(1=Monday,2=Tuesday...7=Sunday ect.)
HOUR Press "Set" button again,"II/H" lights on,
from 01--00(01=1 o'clock,02=2 o'clock...00=24 o'clock ect.)
MINUTE Press "Set" button again,"Fan/M" lights on,
Minutes from 00--59(01=1 Minute,02=2 Minute ect.)
PS:Press "Set" button,screen shows number will
time ,otherwise appliance will get back to standby.
(Appliance will keep the right time until power off)
2) General Using OPERATION
10.
Turn the heater ON by pressing the ON/OFF main button ,the unit will blow the cold air
and "Fan/M" light is on.
11.
Pressing the "MODE" button ,the unit will blow the warm air and both"I/W""Fan/M" lights
are on.
12.
Pressing the "MODE" button second times,the unit will blow the hot air and both
"I/W""Fan/M" lights are on.
13.
Pressing the "MODE" button Three times,the unit will blow the cold air and "Fan/M" light is
on.
PS:Control panel and remote control are same operate way.
3) 24H Timer FUNCTION
1.Open the appliance as working conditions,(fan,warm,hot are all ok).Control panel "TIMER"
button and remote control "
2. Press "TIMER" button ,set the timer up to 24 hours,keep press "TIMER" button to increase the
hours from 00--24(00= close,01=1hour,02=2 hours...24=24 hours ect.) and the "TIMER" light is
on.
PS:set as "00" means no set timer ,the "TIMER" light is off.
current Room temperature. WEEK Press "Set" button one time,"I/W"
two buttons set the week from 1--7
" button are same operate way.
two buttons set the Hours
"
two buttons set the
"
twinkle 5 seconds,you should operate in
" button,light on
22

Publicité

loading

Ce manuel est également adapté pour:

Wtch2000tl