Publicité
Les langues disponibles
Les langues disponibles
BASIC OPERATION (continued)
10. Circuit Breaker
Located on the back of the UPS, the circuit breaker serves to provide overload and fault
protection. Under normal operating conditions, the circuit breaker is depressed.
11. AC Input
Connect the AC Power cord to a properly wired and grounded outlet.
12. Electrical Wiring Fault Indicator (Red)
This LED indicator will illuminate to warn the user that a wiring problem exists, such as bad
ground, missed ground or reversed wiring. If this is illuminated, disconnect all electrical
equipment from the outlet and have an electrician check to ensure the outlet is properly wired.
The unit will not provide surge protection without being plugged into a grounded and properly
wired wall outlet.
REPLACING THE BATTERY
Read and follow the IMPORTANT SAFETY INSTRUCTIONS before servicing the
battery. Service the battery under the supervision of personnel knowledgeable of
batteries and their precautions.
CAUTION!
When replacing batteries, replace with the same number of the following
battery: CyberPower/ RB0690X2 for 0E-RCKMT700. See your dealer for
replacement batteries.
CAUTION!
Risk of energy hazard, 6V, maximum 8AH battery. Before replacing batteries,
remove conductive jewelry such as chains, wrist watches and rings. High
energy through conductive materials could cause severe burns.
CAUTION!
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
CAUTION!
The battery may present the risk of electrical shock. Do not dispose of
batteries in a fire, the batteries may explode. Follow all local ordinances
regarding proper disposal of batteries.
CAUTION!
Do not open or mutilate the batteries. Released material is harmful to the skin
and eyes and may be toxic.
CAUTION!
A battery can present a high risk of short circuit current and electrical shock.
Take the following precautions before replacing the battery:
1.
Remove all watches, rings, or other metal objects from your hands.
2.
Only use tools with insulated handles.
3.
DO NOT lay tools or other metal parts on top of battery or any battery terminals.
4.
Wear rubber gloves and shoes.
Determine if the battery is grounded. If so, remove source of ground. CAUTION: CONTACT
5.
WITH A GROUNDED BATTERY CAN RESULT IN ELECTRICAL SHOCK! The likelihood of
such a shock will be greatly reduced if such grounding is removed during installation and
maintenance.
5
COPYRIGHT © 2023 UltraTech
Publicité
