Ultratech 0E-RCKMT700 Manuel De L'utilisateur page 4

INSTALLING YOUR UPS SYSTEM (continued)
4.
Plug the UPS into a 2 pole, 3 wire grounded receptacle (wall
outlet). Make sure the wall branch outlet is protected by a fuse or
circuit breaker and does not service equipment with large
electrical demands (e.g., air conditioner, refrigerator, copier, etc.).
The warranty prohibits the use of extension cords, outlet strips,
and surge strips in conjunction with the UPS unit.
5.
Press the power switch to turn the unit on. The Power On indicator light will illuminate green
and the unit will "beep" twice.
6.
If an overload is detected, an audible alarm will sound and the unit will emit one long beep.
To correct this, turn the UPS off and unplug at least one piece of equipment from the battery
power supplied outlets. Make sure the circuit breaker is depressed and then turn the UPS
on.
7.
To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all times.
8.
To store the UPS for an extended period of time, cover it and store with the battery fully
charged. While in storage, recharge the battery every three months to ensure optimal battery
life.
9.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
3 COPYRIGHT © 2023 UltraTech