Bradley Advocate AV Serie Manuel D'installation page 17

Installation
7b Valve Assembly
Attach angle stops to hot and cold
B
stub outs. Attach 1/2" supply hoses
to hot and cold supply stops.
Supply Hose, Cold
½" x 24"
Angled Supply Stop
⁵⁄₈" O.D. x ³⁄₈" O.D.
Bradley • 215-1771 Rev. D; ECN 13-08-028
Supply Hose, Hot
½" x 24"
Attach transformer circuit plug to
transformer connector plug on
D
gang valve bracket. Attach gang
valve to the wall. See Step 1a for
valve bracket anchor locations.
For clarity, the front dryer
hose is not shown.
Loosen the compression nut. Push the supply
A
tube firmly into the tube connector until it is
seated. Retighten the compression nut by hand.
Single Valve (TMA valve is shown. TL valve is similar.)
Valve,
Cold Supply
1/21/2014
AV30
C
Attach hot and cold
hoses to the valve.
Valve, Hot Supply
17