Publicité
Les langues disponibles
Les langues disponibles
To enter your product settings, press the "+" and "-" buttons on your screen for 5 seconds.
Warning ! If you change all the basic settings, you will change the performance and status of your product. You
are advised to change only the settings below :
Menu
P01
P02
P04
P09
ERROR
E06
Check that your battery is fully charged. If so, check that the battery compartment (tray) is not damaged. Then check the
E07
E08
E09
E10
Lost signal, check the condition of your product's cables. This problem may come from the motherboard or the screen.
E11
Lost signal, check the condition of your product's cables. This problem may come from the screen.
E30
Go to the settings of your product by pressing and holding the "+" and "-" buttons. Go to the P20 setting and enter 0.
Lubrification
The folding system of your scooter needs to be lubricated every 6 months with a neutral
non-corrosive oil.
When your brake performance begins to decline, you can adjust the
Setting the distance measurement unit
0 = No sleep mode
0 = Immediate start
Check the condition of the cables of your product. Then check the condition of the motor(s).
Check that the throttle trigger is in good condition. Check the condition of your product's cables.
Check the condition of your product's cables. Change the motherboard.
Maintenance
sensitivity of your brake cables.
System settings
Settings
Brightness adjustment
0 = KM
1=MILES
Screen saving time
1 to 60 = The number of minutes of standby time
Startup mode
1 = Impulse to start
Error codes
PROBLEMS
Battery
condition of your product's cables.
Motor
Accelerator
Motherboard
Receiving cable
Transmitter cable
Communication error
28
Brake
Publicité
