Danfoss TP5000 Instructions D'installation page 11

Changing the preset programmes
For Days 1-5 (weekdays)
a) Press PROG until 1st pre-set time and
temperature (Event 1, Days 1,2,3,4,5)
appears in display.
b) Use + or – buttons to adjust the TIME
(press and hold to change in 10 min
increments).
c) Use s or t buttons to adjust the
TEMPERATURE.
d) Press PROG to move to next preset time &
temperature (Event 2).
e) Repeat steps b, c & d for programming
Events 3, 4, 5 & 6.
For Days 6-7 (weekends)
o Press PROG until 1st pre-set time and
temperature (Event 1 Days 6-7) appears
in display.
o Repeat steps b, c and d above to
programme time and temperature
events for the weekend.
If you require just 2 Events per day (1 ON / 1 OFF)
o Follow steps a, b & c above to programme
Event 1 (ON).
o Press and hold t and - buttons
together for 3 seconds to skip events
2,3,4 & 5.
o Follow steps b & c to programme Event 6 (OFF).
To revert back to six events per day, reset the thermostat (see page 9).
6 30
1
20
8 30
2
15
7 00
1
20
GB
11