Tool Assembly - Michelin MOP 300 Notice D'utilisation

4. TOOL ASSEMBLY

Position the cap (5) on the gearbox such that the holes for mounting the
screws (7) are aligned with those on the gearbox.
5. ACCESSORIES ASSEMBLY
5.1. POLISHING DISC (A)
Fix the output shaft with the wrench(4), then slightly turn the polishing disc (6)
until it is fixed to the output shaft.
5.2. POLISHING FOAM (B)
5.2.1. Place the polishing pad (8) on one polishing disc and press it into
position with a slight turn.
5.2.2. To remove the polishing pad, take hold of it at one corner and pull it
upwards.
6. START AND STOPPING
6.1. Starting: push the lever of the switch (2) handle.
6.2. Stopping: push and release the lever of the switch (2).
The tool continues to rotate after it is turned off.
Do not run to "empty" the tool with the polishing pad mounted. In this
way, the polishing pad may be subject to lacerations.
7. SELECTING RPM (min
The rpm can be adjusted by rotating the speed wheel (3). The choice of speed
depends on the characteristics of the abrasive disc and the material to be
worked with.
8. ALLOWED ACCESSORIES
Polishing foam Ø 130-150 mm for backing pad Ø 125 mm.
-1
)
9