Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Grease filters
Odour/fine particle filter
Remove the filters by pulling on their release handles.
Use an odour/fine particle filter when the cooker hood is not connected
to an exhaust duct.
The functioning:
• More noise is produced when carbon filters are used than when the
cooker hood is used with an exhaust vent.
• Carbon filters function optimally at a lower motor speed. For this
reason, avoid the intensive setting.
Replacing the odour/fine particle filter
The odour/fine particle filter must be replaced annually. To replace
the filter, follow the instructions supplied with the new filter. The
recirculation set HR0014 must be ordered for the first installation.
1. Remove the grease filter.
2. Remove the filter holder by loosening the screw and removing the
holder at an angle from the appliance.
3. Remove the filter and place a new filter back in the holder. Note the
arrow on the filter for correct placement!
4. Place the filter holder back in the appliance and tighten the screw.
5. Install the grease filter.
EN 13
Publicité
