Hotpoint ENBYH 19 F O3 Serie Mode D'emploi page 23

Maintenance and care
Switching the appliance off
During cleaning and maintenance it is necessary to disconnect
the appliance from the electricity supply:
1. Press the ON/OFF button to switch off the appliance.
2. Pull the plug out of the socket.
! If this procedure is not followed, the alarm may sound. This
alarm does not indicate a malfunction. To restore normal operation
insert the plug into the socket, press the FREEZER OPERATION
and SUPER FREEZE button and set the FREEZER OPERATION
button on the desired value.To disconnect the appliance, follow
point 1 and 2.
Cleaning the appliance
• The external and internal parts, as well as the rubber seals may
be cleaned using a sponge that has been soaked in lukewarm
water and bicarbonate of soda or neutral soap. Do not use
solvents, abrasive products, bleach or ammonia.
• The removable accessories may be soaked in warm water and
soap or dishwashing liquid. Rinse and dry them carefully.
• The back of the appliance may collect dust which can be
removed by delicately using the hose of a vacuum cleaner set
on medium power. The appliance must be switched off and
the plug must be pulled out before cleaning the appliance.
Avoiding mould and unpleasant odours
• The appliance is manufactured with hygienic materials which
are odour free. In order to maintain an odour free refrigerator
and to prevent the formation of stains, food must always be
covered or sealed properly.
• If you want to switch the appliance off for an extended period
of time, clean the inside and leave the doors open.
I Care function
The I Care function can be activated to optimise energy
consumption while maintaining the cooling performance of the
product.This function maximises the amount of energy saved.
Under these conditions, the display remains off even when the
door is opened. The function is activated by pressing and holding
the super freezer and FRZ (+) buttons simultaneously for at least
6 seconds. Once the function has been activated, all LEDs will
light up for 2 seconds to confirm activation, and the temperature
setting of +5, -18 will appear on the display. The display switches
off after 5 seconds. To change the temperature, simply press the
+ and – buttons until you have reached the desired temperature.
However, the I Care function can also be disabled by switching
the product off using the ON/OFF button. When it is switched back
on, the I Care will be disabled.In humid environments, when the
I Care function is enabled, slight condensation may form on the
appliance door; normal operating conditions are restored when
the function is disabled.
Replacing the led*
Thanks to the powerful light it emits, the new LED lighting system
offers a clear view of all foods, with no shadowy areas. If the LED
needs to be replaced, please contact the Technical Assistance
Service.
All manuals and user guides at all-guides.com
Replacing the light bulb *
To replace the light bulb in the refrigerator compartment, pull out
the plug from the electrical socket. Follow the instructions below.
Access the light bulb by removing the cover as indicated in the
diagram. Replace it with a similar light bulb within the power range
indicated on the cover.
Precautions and tips
! The appliance was designed and manufactured in compliance
with international safety standards. The following warnings are
provided for safety reasons and must be read carefully.
This appliance complies with the following Community Directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent
amendments;
-89/336/EEC of 03.05.89 (Electromagnetic Compatibility) and
subsequent amendments;
- 2002/96/CE..
General safety
• The appliance was designed for domestic use inside the home
and is not intended for commercial or industrial use.
• The appliance must be used to store and freeze food products
by adults only and according to the instructions in this manual.
• The appliance must not be installed outdoors, even in covered
areas. It is extremely dangerous to leave the appliance
exposed to rain and storms.
• Do not touch the appliance with bare feet or with wet or moist
hands and feet.
• Do not touch the internal cooling elements: this could cause
skin abrasions or frost/freezer burns.
• When unplugging the appliance always pull the plug from the
mains socket, do not pull on the cable.
• Is not sufficient to switch-off of the product to eliminate all the
electrical connections.
• In the case of a malfunction, under no circumstances should
you attempt to repair the appliance yourself. Repairs carried
out by inexperienced persons may cause injury or further
malfunctioning of the appliance.
• Do not use any sharp or pointed utensils or electrical equipment
- other than the type recommended by the manufacturer - inside
the frozen food storage compartments.
• Do not put ice cubes taken directly from the freezer into your
mouth.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or lack of experience
and knowledge unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance.
• Keep packaging material out of the reach of children! It can
become a choking or suffocation hazard.
Disposal
• Observe local environmental standards when disposing
GB
23