Dynafit BOOTS PDG 2 Notice D'emploi page 4

securely hold your leg on the descent. If the adjustment of the Velcro band is not
adequate, you can also adjust the length of the Kevlar
making a shorter loop.
• WALK/RUN MODE: Once the cables are correctly adjusted, simply open the cuff buckle
to simultaneously release the cuff and unlock the ski/walk mechanism. This simple and
fast movement will allow you to walk or run freely with incredible agility.
• DOWNHILL SKI MODE: To simultaneously tighten the cuff width and lock the ski/walk
mechanism, simply close the cuff buckle. Once the buckle is closed, it will automatically
lock the cuff into place.
ADJUSTABLE FORWARD LEAN SPOILER: The PDG 2 is designed with a new internal
spoiler which allows the modification of the forward lean angle in ski mode.
To adjust between position 1 and position 2 open completely all boots buckles, remove the
inner boot and with a torx key unscrew the metal insert visible on the spoiler center. Rotate
the insert and reposition the screws, tighten them strongly.
CL LINERS: Always refer to an authorized DYNAFIT retailer when molding your liners.
In order to get the best fit and to be covered by the warranty we recommend using only
blowing heat towers shown on the picture (1) and not other heating systems.
PDG 2 LINER MOLDING LINERS: Remove the footbed (if present) before heating the
cable by cutting it shorter and
®
liner. Warm up the liners with air blowing heating system. Do all shaping with the liners
in the boots to avoid damaging them. During the heating time prepare your feet wearing
the socks you usually use during the activity, put the toe caps on your toes in order to
gain room on the toe box (2) and the
Nylon socks useful to slip into the boot (3). Just a bit before the countdown is finishing,
take out the first boot and leave the second one on the machine. Place the footbeds (if
needed) back into the boot before stepping in. Place your foot into the boot helping you
with a shoehorn. Close the boot into downhill mode to a level of medium tightness. Walk
on the heels in the first 10 seconds, then remain in a stable standing position and wait at
least 10 minutes to allow the liner to cool down. Repeat these points for the second boot.
External abrasion on thermoformable liners is normal. In the boot box, special patches
are provided to reinforce your liners if you start to see abrasion occurring on the outside of
the liners.
CARE AND MAINTENANCE OF YOUR DYNAFIT BOOTS:
• Use only mild soap and water to clean your boots.
• If the liners are wet, remove them from the shells. Take out the footbeds and place
both in a warm, dry place. Keep them away from direct heat sources, such as radiators,
fireplaces, or ovens, as this may cause damage or change the fit.
• Before storing your boots, make sure that the liners and shells are dry. Fit the liners
into the shells, lightly close buckles and then store boots in a dark, dry place, away
from any sources of direct heat. Ideally, store your boots in the original box, or a box