Far Tools 118015 Notice Originale page 21

EN
SAFETY INSTRUCTIONS AND REGULATIONS
To ensure optimal working and safety conditions, please read the following sections carefully
One of the fundamental factors in safety is adherence to the maintenance fre-
quency (see maintenance table). In addition, never attempt to carry out repairs or
maintenance operations, if you are lacking experience and/or the tools required
ELECTROCUTION
During use, generator sets output electrical power.
- Never touch bare cables or disconnected connections.
- Never handle a generator set while your hands or feet are wet
- Never expose the equipment to liquid projections or adverse weather conditions
or place it on a wet floor. Keep electrical cables and connections in good condi-
tion.
- Using equipment in poor condition may result in electrocutions or damage to the
equipment.
- Provide a differential protective device between the generator set and the equip-
ment is the length of the operating cable(s) is over 1 metre.
- Use flexible and resistant cables with a rubber sheath, in compliance with IEC
245-4 or equivalent cables.
- The generator set must not be connected to other power sources such as the
mains network. In specific cases in which a backup connection to electrical
networks is provided for, it must only be carried out by a qualified electrician, who
must take the functional differences of the equipment into consideration, depen-
ding on whether the mains network or the generator set is used.
- Electric shock protection depends on circuit breakers provided specially for the
generator set. If the circuit breakers need to be replaced, they must be replaced by
a circuit breaker with identical rated values and specifications.
© FAR GROUP EUROPE
118015-3-Manual-G.indd 21 25/10/13 9:19:27