Buhnen HB 225 Mode D'emploi page 16

Operation
Attention!
Observe the following instructions to prevent the risk of
injuries and damage to the device:
1. Never lay down the device on its side in its hot operative
2. Never remove adhesive residues from the melting
3. Never loosen cooled off hot-melt adhesive sticks by
4. You should never pull the cold glue stick out of the
5. Never use the trigger (3) with force.
6. Comply with the processing data sheet of the hot melt
7. When working upside down, watch out for possible drips
8. Always disconnect the mains plug before carrying out
4.1 Initial operation
1. Plug the mains plug into a protective earth conductor outlet.
2. Switch on the device at the on/off switch (5).
3. The device has an electronic temperature control that is operated by
a turning knob on the stand. The temperature can be set between
140 - 230°C. Turning the knob clockwise increases the temperature.
An LED display (8) next to the turning knob (7) shows the status of the
device:
- blue light = device is heating up
- green light = device is ready for operation
Please wait a further 6 - 8 minutes before starting.
HB225XM_210727.indd 16
state. This could cause the filling material to leak un-
checked. Danger of burns!
chamber by force (e.g. with a scraper or screwdriver).
This could damage the interior lining of the melting
chamber.
force (e.g. with tongs).
device. This can cause damage to the transport mecha-
nism.
adhesive (protection against processing errors).
to avoid burns to personnel or work items.
any work on the device (maintenance, cleaning).
16
GB
04.08.21 08:41