Waeco CoolMatic HDC-270 Instructions De Montage Et De Service page 36

_HDC270.book Seite 36 Montag, 18. Oktober 2010 8:12 20
Installing the refrigerator
➤ Make sure the upper bracket of the refrigerator touches the cabinet
(fig. 0 1, page 8).
➤ Fasten the right side of the refrigerator as shown in fig. 0, page 8 to
fig. b, page 9.
➤ Fasten the left side of the refrigerator as shown in fig. c, page 9.
6.3 Connecting the doors of the refrigerator to the
doors of the cabinet
The refrigerator has sliding hinges so that the doors of the refrigerator can be
connected to the doors of the cabinet.
➤ Connect the doors of the refrigerator to the doors of the cabinet as shown
in fig. d, page 10 to fig. e, page 10.
6.4 Connecting the refrigerator to the power supply
Connecting to a battery
NOTICE!
A
To avoid voltage drops and loss of performance, keep the con-
nection cable as short as possible and not be interrupted.
For this reason avoid additional switches, plugs or multi-way
adapters.
Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick charg-
ing device.
Overvoltage can damage the electronics of the device.
The refrigerator can be operated with a 12 volt to 24 volt DC voltage supply.
For safety reasons, the refrigerator is equipped with an electronic system to
prevent the polarity being reversed. This protects the refrigerator against re-
versed polarity when connecting to a battery and against short circuiting.
36
HDC-270