Westinghouse WSHPTCNSK52 Manuel D'instructions page 13

USING THE HEATER
NOTE: The buttons for operating the heater on the heater control
panel and the remote control are the same. The indicator light will
illuminate the icon of the function that is selected.
Press the POWER switch (1) to the on position I. The switch's
1.
red indicator light will illuminate and OF appears on the screen.
2. Press the ON/OFF button (11) on. The fan mode will start, the
indicator light will illuminate the fan icon
the screen.
3. Press the MODE button (14) repeatedly to select one of the
following options:
LO – Heater low (750W)
•
• HI – Heater high (1500W)
• 25 – Economy – The heater will adjust the power level to
maintain the set temperature. The default temperature for this
mode is 25°C / 77°F.
NOTE: The indicator light will illuminate the icon of the function
that is selected. The fan remains on during all heater modes.
4. You can only set the temperature in economy mode. To set
the temperature, press the UP/DOWN buttons (13) to increase
or decrease the temperature to your desired level. The
temperature range is from 15°C to 35°C / 59°F to 95°F. The fan
and heater will turn on and off to keep the room at the set level.
NOTE: In economy mode, the heater must be set to a temperature
level that is at least a few degrees higher than the room
temperature for the heating function to be activated. If the heater
does not appear to be working, increase the temperature until the
heating function turns on.
5. To oscillate (swing) the heater through 60 degrees, press the
OSCILLATING button (12). The oscillating icon illuminates
when this function is on.
6. To stop the swing while the appliance is oscillating, wait
until the airflow is in the desired position and press the
OSCILLATING button (12).
HOW TO USE
, FA appears on
EN
13