Publicité
Les langues disponibles
Les langues disponibles
Operations (continued)
■ USB operation
It is possible to listen to music via the USB device
interface of the unit.
Connecting a USB device:
1.
Switch the unit on and select USB mode by pressing
button on the unit, or the INPUT button on the
the
remote control.
2.
Connect the USB device to the USB terminal on the
front panel of the unit.
3.
The unit will now play songs which are saved on the
USB device.
Troubleshooting
Many potential problems can be resolved by the owner without calling a service
technician. If something is wrong with this product, check the following before
calling your authorised dealer or service centre.
Problem
Description
The unit is not
powered on
No Sound from
AUX/Bluetooth input
Sound is distorted from
LINE IN Input
Unable to play CD
Static Sound
Desired station not found
Unit switches off after 15
minutes of inactivity
CD-BH10_EN.indd 12
CD-BH10_EN.indd 12
Cause
• Power cable not connected to wall socket
• Power socket is not switched on
• Volume is too low
• LINE IN/Bluetooth source volume is too
low
• Volume is too high
• LINE IN source volume is too high
• No disc in the tray
• Disc not loaded properly
• Disc is dirty
• Poor reception
• Weak signal
• Station not available in your area
• Auto standby mode in operation
E-12
Notes:
●
MP3 format is supported.
●
Unsupported file formats are skipped. For example,
Word documents (.doc) or MP3 files with extension .dlf
are ignored and not played
●
Even when the files are in a supported format (MP3),
some may not play or display depending on the
compatibility.
●
In some case, reading may be as long as 60 seconds,
this is not a malfunction.
●
Depending on the amount of data and media speed,
it may take longer for the unit to read the USB device.
●
The maximum USB memory size is 32GB.
●
USB memory device must be formatted in FAT, FAT16
or FAT32
Solution
• Make sure the plug is connected
• Switch the power on
• Increase the volume
• Increase the output volume of
the LINE IN source
• Reduce the volume
• Reduce the output volume of
the LINE IN source
• Insert a compatible disc
• Check the disc loaded correctly
• Clean the disc
• Re-locate the antenna (FM)
• This unit is designed to enter STANDBY
mode automatically after 15 minutes of
inactivity. Press the STANDBY button to
wake up the unit.
7/7/23 2:49 PM
7/7/23 2:49 PM
Publicité
