Publicité
Les langues disponibles
Les langues disponibles
System connection
■ Preparation for use
Make sure to unplug the AC power cord
before making any connections.
2
CAUTION:
TO PREVENT ELECTRIC
SHOCK MATCH WIDE BLADE
OF PLUG TO WIDE SLOT,
FULLY INSERT.
6
USB
4
LINE IN
1.
Please ensure that the voltage marked on the rating
label on the rear panel is the same as the voltage in
your area. Insert the end of the power lead into the AC
IN socket on the back of the unit. Plug the other end of
the cable into the wall socket.
2.
Press the STANDBY button on the main unit to turn it
ON. Extend the ANTENNA to get the best reception.
Press the source button on the unit, or FM button on
the remote control to enter the FM mode. To use the
radio in FM mode, follow the instructions in the FM
RADIO OPERATION chapter.
3.
Press the
button on the unit, or INPUT button on
the remote control button to enter the CD mode. Press
button to open the disc drawer and insert a disc.
the
Press the
button again to close. The CD will begin
playing from the first track.
4.
Press the
button on the unit or the INPUT button
on the remote control button to enter the LINE IN
(Audio) mode. Connect your audio device to the LINE
IN socket via a 3.5mm aux-in cable. Control playback
via your connected audio device.
CD-BH10_EN.indd 10
CD-BH10_EN.indd 10
1
AC outlet
(AC 100 - 240V
~50/60 Hz)
5
3
E-10
5.
Press the
button on the unit or the INPUT button
on the remote control button to enter Bluetooth mode.
Activate the Bluetooth-enabled device and select the
"CD-BH10 SHARP". Select the song you want and
press to play.
6.
Press the
button on the unit or the INPUT button
on the remote control to enter the USB mode. Plug the
USB device into the USB port on the unit's front panel,
and it will read the USB and play automatically.
■ Basic functions
Switching modes
To switch between the modes: CD, FM, Bluetooth, USB
and LINE IN, press the
button on the unit or the INPUT
button on the remote control.
Volume control
1. Increase: Rotate the VOLUME control on the main unit
clockwise or press the VOL+ button on the remote.
2. Decrease: Rotate the VOLUME control on the main unit
anticlockwise or press the VOL- button on the remote.
EQ effects
Press the EQ button on the remote repeatedly to cycle
through a set of equalizer presets to adjust the sound.
Choose from CLASSIC, ROCK, POP, JAZZ, DANCE,
LIVE and Off.
Mute function
Press the
button at any time to mute the sound output.
Press again to unmute.
Standby mode
Press the STANDBY button on the unit or the remote to
put the system into standby mode. To resume normal
operation, press this button again.
Note: This unit is designed to enter STANDBY mode
automatically, after about 15 minutes (approximately) of
inactivity. Press STANDBY button to wake the unit.
Note: When you power on the unit from standby, it will
resume in the mode that was last used.
7/7/23 2:49 PM
7/7/23 2:49 PM
Publicité
