Publicité
Les langues disponibles
Les langues disponibles
electrical connection
A
Lower the upper chimney.
B
1.
Remove the power supply cover by undoing the (2)
2. Route the power cord to the junction box.
3. Using listed conduit fittings and connectors, connect the power supply to the box and
each line to the appropriate wire following this color convention:
BLACK = HOT LEG
WHITE = NEUTRAL
GREEN/YELLOW = GROUND
Polarity must be observed.
Unit must be properly grounded.
Use a double throw disconnect switch.
4. Replace the box cover
Replace the Anti-grease flters.
All wiring must be in compliance with national electrical code, ANSI/NFPA 70-1999
and all local codes and regulations.
C
Perform the necessary electrical connections between the cooker hood body and the
motor assembly.
A
C
screws.
B
- 17 -
Publicité
