Publicité
Les langues disponibles
Les langues disponibles
installation
Please note!
Before beginning the assembly procedure, for easier cooker hood handling, open
the packaging, remove the cooker hood and place it on a convenient surface.
Open the panel by pressing the point indicated in Fig. 1.
Remove the aluminium panel by pulling the handle as indicated in Fig. 2.
The product is supplied pre-assembled. To install it, proceed as follows: remove the
structure from the packaging and remove the 2 screws A to separate the upper part
from the lower part (Fig. 3).
•
Position the drilling template on the ceiling, making sure that the arrow is on
the right-hand side in relation to the appliance controls, as indicated in Fig. 4.
•
Make 4, Ø8 holes in the ceiling and drive in 3 screws without completely tight-
ening them. Pay attention not to insert the screw into the hole marked with an
1
2
3
- 13 -
4
Publicité
