Publicité
Les langues disponibles
Les langues disponibles
EN
3. Put the chain drive links (21) into the bar groove (20).
4. Put the chain cutters (22) in the direction of the chain
operation.
5. Put the chain in position and make sure that the loop is
behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket (17).
8. Make sure the chain tension pin hole (19) on the guide
bar fits correctly with the bolt (18).
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the chain cover knob when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
4
22
21
20
18 19
17
NOTE
English
12.4
CONNECT THE POLES
3
1. Insert the intermediate pole into the rear handle.
2. Tighten screws with screwdriver (not included).
12.5
ADJUST THE LENGTH OF THE
POLESAW
8
1. Loose the collar (9) by turning it counterclockwise.
2. Pull / Push the telescoping shaft (8) to adjust the length of
the polesaw.
3. Turn the collar clockwise to tight it.
12.6
CONVERT CHAINSAW TO
POLESAW
1. Lift the quick release latch (16) and cover at the bottom
of the chainsaw.
2. Insert the telescoping shaft to the chainsaw.
10
9
Publicité
