Avanti SLTW44D0W Manuel D'instructions page 9

CONNECTING THE WATER SUPPLY HOSES (HOSES ARE NOT INCLUDED)

The water supply hose must be connected to the washing machine at one end and to the water faucet
at the other. Do not stretch the water supply hose. If the hose is too short and you do not wish to move
the water faucet, replace the hose with a longer, high-pressure hose.
Select appropriate faucet as shown in the figures below. If none of these faucets are available, use the
faucet adapter provided.
The end of faucet spout should be longer than 10mm (0.4"), or the connector cannot be fixed properly.
Water leakage could develop.
1. Connect the water inlet hose to the
faucet by turning the connecting nut.
1. Connect the water inlet hose to the
faucet by turning the connecting nut.
Rubber ring seal
Rubber ring seal
Be sure a rubber ring is inside the connecting nut.
Be sure a rubber ring is inside the connecting nut.
If you have both cold and hot water supplied, connect the inlet hoses by cold to cold and
If you have both cold and hot water supplied, connect the inlet hoses by matching cold to cold and hot
hot to hot.
to hot.
If you have both cold and hot water supplied, connect the inlet hoses by cold to cold and
1. Connect the water inlet hoses to the faucets
hot to hot.
by turning the connecting nuts.
1. Connect the water inlet hoses to the faucets
by turning the connecting nuts.
CONNECTING
NUT
CONNECTING
NUT
WATER INLET HOSE
Be sure the rubber rings are inside the connecting nuts.
WATER INLET HOSE
Be sure the rubber rings are inside the connecting nuts.
 Note:
If you do not want to use the hot water supply hose, insert a water intake cap (not included, must
purchase separately at any home center) into the hot water supply intake hole. In this case you must
select "Tap Cold" option for the water temperature with each use.
CONNECTING
NUT
CONNECTING
NUT
CONNECTING
NUT
CONNECTING
NUT
2. Then connect the other end of water
inlet hose to the cold connector in
water mixing valve by turning the
2. Then connect the other end of water
connecting nut.
inlet hose to the cold connector in
water mixing valve by turning the
connecting nut.
CONNECTING
NUT
WATER
INLET HOSE
CONNECTING
NUT
WATER
INLET HOSE
2. Unscrew the lid of hot water connector
in water mixing valve, and then connect
the other end of water inlet hoses to the
2. Unscrew the lid of hot water connector
connectors in water mixing valve by
in water mixing valve, and then connect
turning the connecting nuts.
the other end of water inlet hoses to the
CONNECTING
connectors in water mixing valve by
NUT
turning the connecting nuts.
CONNECTING
WATER
NUT
INLET HOSE
WATER
INLET HOSE
9
LID OF
HOT WATER
CONNECTOR
LID OF
HOT WATER
CONNECTOR
COLD WATER
CONNECTOR
COLD WATER
CONNECTOR
HOT WATER
CONNECTOR
HOT WATER
CONNECTOR
COLD WATER
CONNECTOR
COLD WATER
CONNECTOR