Publicité
Les langues disponibles
Les langues disponibles
EN
Sanding wheel speed regulation
The sanding of the grinding disk rotation speed can be adjusted according to different conditions and grinding quality requirements.
G
G
Telescopic pipe
According to the needs of different grinding positions, the length of the machine can be adjusted between 1000-1850mm. Rotate the locking nut
counter-clockwise to loosen, pull the pipe to the desired length, and then rotate the locking nut clockwise rotating in order to fix (lock) the pipe at the
desired position.
H
H
Maintenance
Keep tools clean, remove debris and dust. Add lubricating oil and grease (reducer, bearings) frequently to keep the tool working properly. Always check the
power cord, plug, switch, and make sure they are in good condition. In case of malfunction, contact an authorized service center.
Carbon brush replacement
The accessories include an original set of carbon brush, when the carbon brush is worn, replace it with a new one. Use a screwdriver to unscrew the brush
cover, remove the original carbon brush, put new carbon brush to brush holder and screw back the brush cover.
J
J
8
Speed adjuster
Locking nut
WWW.NIKOLAOUTOOLS.GR
Publicité
