Publicité
Les langues disponibles
Les langues disponibles
5. REPLACING FAULTY COMPONENTS
Diagnosis of Common Fault:
Fault
Cause Analysis
Failure in ignition
1. There is no gas supply or the gas pressure dose
not fit.
2. The valve of the appliance is damaged.
3. The ignition electrode has loosened and shifted.
The fire goes out
4. The fire detector has dislocated or the lead has
immediately after
dropped.
successful ignition
5. Lack of oxygen for combustion
6. The gas pressure is too low or the gas supply is
insufficient.
The above types of faults are for reference only. In case of fault, stop using the appliance immediately and contact
professional maintenance workers for repair or contact the supplier as possible.
6. TECHNICAL DATA
SHEET 1
MODEL
7539.0005/0010/0025/0030
7539.0015/0035
7539.0020/0040
SHEET 2
MODEL
7539.0005/0010/0025/0030
7539.0015/0035
7539.0020/0040
Inlet pressure (mbar)
Injector orifice (mm)
Destination countries
Complied standard
This appliance shall be installed in conformity with the current regulations and used only in a well-
ventilated location. Consult the instructions before installing and using this appliance.
PLATE SIZE
BURNERS
(WxD)
1
350x400mm
2
600x400mm
3
750x400mm
BURNERS
I3+(28~30/37)
1
3.0× 1
2
3.0× 2
2
3.0× 2
29
0.9
BE, CH, CY, CZ, ES,
FR, GB, GR, IE, IT,
PT, SI
EN203-1:2005 Gas Heated Catering Equipment-Part: General
Safety Rules. EN203-2-9:2005 Specific requirements- Solid tops,
Warming Plates and Griddles
www.combisteel.com
Solution
1. Check the air inlet and the gas
pressure.
2. Replace the valve of the
appliance.
3. Adjust the position of the
ignition electrode and make it
firm.
4. Adjust the fire detector to allow
the flame to go red.
5. Maintain good ventilation.
6. Check and replace the gas, or
turn up the gas supply valve.
PRODUCT SIZE
(WxDxH)
400x570x350mm
650x570x350mm
800x570x350mm
HEAT INPUT (KW)
I3B/P(50)
I2H(20)/I2E(25)
3.0× 1
3.0× 2
3.0× 2
50
0.78
AT, CH, CZ, DE, DK,
EE, ES, FI, FR, GB,
AT, CH, DE, FR, SK
GR, IE, HU, IT, LT,
LV, NL, NO, PT, RO,
3.1× 1
3.1× 2
3.1× 2
20
1.3
SE, SI, SK
6
Publicité
