GYS GYSDUST EXTRACTOR Manuel D'utilisation page 16

Operating manual
Steps for fitting the dust bag
1 - Carry out this operation with the metal clamp connected to the earth circuit of the installation.
2 - Close the compressed air supply valve on top of the hoover.
3 - Disconnect the quick disconnect power connector on the
back of the hoover before opening the rear cover. Use the flush
latches to open the bonnet.
4 - Unhook the flange of the dust bag from the suction port, close the dust bag with the cap provided to prevent dust
from escaping from the bag during transport. Carefully lift the dust bag and place it in a designated area within the
ATEX installation.
5 - Remove any dust deposits inside the bucket.
6 - Place a new dust bag in the bucket, connecting the flange to the suction port.
7 - Check for breaks or tears in the filter cloth.
8 - Close the cover by slamming it shut, making sure not to tear the bag.
9 - Connect the compressed air supply to the rear of the hoover with the quick coupling provided.
Mouth
suction
16
Translation of the original
instructions
GYSDUST EXTRACTOR
Désignation:
Aspirateur pneumatiq
Produit:
Nom du fichier CAO:
Ce document est la prop