GYS GYSDUST EXTRACTOR Manuel D'utilisation page 13

Operating manual
WARNINGS - SAFETY RULES
GENERAL INSTRUCTION
This user's manual contains information on the operation of the device and the precautions to be
taken for the safety of the user. Please read it carefully before using the machine for the first time and
keep it for future reference.
These instructions must be read and understood before any operation.
Any modification or maintenance not specified in the manual must not be undertaken.
The manufacturer shall not be liable for any damage to persons or property arising from use not in
accordance with the instructions in this manual.
In case of any problem or uncertainty, please consult a qualified person to handle the appliance
correctly. THIS UNIT SHOULD ONLY BE USED TO EXTRACT DUST FROM THE SANDING
OF CAR BODIES, WHICH MAY BE ALUMINIUM. The storage of aluminium particles requires
specific precautions in accordance with the ATEX standard.
The safety instructions must be observed. In case of improper or dangerous use, the manufacturer
cannot be held responsible.
Use only the accessories supplied with the appliance or those specified in the instruction manual. The
use of other accessories may compromise safety.
The sound pressure level (noise) emitted by the device during operation is L= 70 dB(A).
Knowledge and awareness of the risks of working in ATEX zones is essential for the use of this
equipment.
The device belongs to group II category 3D according to the classification of the ATEX Directive. It is
therefore suitable for use in Zone 22.
This means that it can be used in places where an explosive dust atmosphere, in the form of a cloud
of combustible dust in the air, is not likely to occur during normal operation, but may persist only for
a short time.
CONNECTION
This appliance must be grounded using the clamp provided.
Connect the ground clamp of the product to a part connected to ground of the building.
CAUTION : Always connect the ground of the product to the ground of the building, especially when
using the dust extractor, or when emptying the dust bag or replacing it.
MAINTENANCE
• Maintenance should only be carried out by a qualified person.
The instruction manual should give details of the following, if applicable:
• Warning! Always disconnect the compressed air supply before working on the device.
• The bag is considered full and should be emptied when it contains 7 kg of dust. In this situation, this
corresponds to a dust height of 8 cm.
• A decrease or loss of aspiration may be observed in some cases:
- The suction module no longer sucks, even with a new bag. The ducts of the suction module are
clogged and push air into the hose. These dust accumulations can occur when the suction module is
used for a long period of time with a full bag, or when wet materials are sucked in, resulting in a thicker
and thicker film in the suction module ducts.
Cleaning with the brush in the ducts removes this dust and the suction module returns to its
original performance.
• Regularly remove the cover and blow out the dust. Take the opportunity to check the earth connec-
tion (clamp and cable)
• Never use solvents or other aggressive cleaning agents
• Clean the surfaces of the device with a dry cloth.
Translation of the original
instructions
GYSDUST EXTRACTOR
13