Parkside 385623 2107 Traduction Des Instructions D'origine page 25

6-part cutter set:
24 Profile cutter (Ø 25 mm, R 4 mm)
25 Rounding cutter
(Ø 22 mm, R 6.3 mm)
26 V-notch cutter (Ø 12.7 mm,
27 Notch cutter (Ø 12 mm)
28 Notch cutter (Ø 6 mm)
29 Fillet cutter (Ø 22 mm, R 6.3 mm)
Functional description
The battery-powered router cutter is a
power tool equipped with a rotating cut-
ting tool (milling cutter) and a baseplate.
Stepless cutting depth adjustment and dust
suction enable comfortable working.
Refer to the following descriptions for a
functional description of the controls.
Technical data
Cordless Router ...................... POFA 12 B3
Motor voltage U
max
Idling speed n ......................19000 rpm
0
Milling cutter diameter .......... max. 36 mm
Rotational speed
of cutter n .....................max. 35000 rpm
Tool holder .......................... 6 mm/8 mm
Weight (without rechargeable
battery) .............................approx.1,1 kg
Sound pressure level
(L ) ...................... 66,8 dB(A); K
pA
Sound power level (L
Vibration (a
) ....... 2,031 m/s
h
Temperature...........................max. 50 °C
Charging process ...................4 - 40 °C
Operation .......................... -20 - 50 °C
Storage .................................0 - 45 °C
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
)
......................12 V
=3 dB
pA
) 77,8 dB(A); K
=3 dB
WA WA
; K=1.5 m/s
2
The specified vibration emission value and
the stated noise emission value have been
measured according to a standardised test
method and can be used to compare one
90°)
power tool with another.
The specified vibration emission value and
the stated noise emission value can also
be used for a provisional assessment of the
load.
Warning:
The vibration emission value whilst
actually using the power tool may
vary from the given values depend-
ing on the type and way in which
the power tool is used as well as
the type of workpiece being pro-
cessed in particular.
Try to keep the exposure to vibra-
tions as low as possible. One
example of a measure to reduce
vibration exposure when using the
tool is limiting the working hours.
All parts of the operating cycle
have to be considered while doing
so (for example, times when the
power tool is switched off and times
when it is switched on but running
without any load).
Charging time
The device is part of the Parkside X 12 V
TEAM series and can be operated with
2
batteries of the Parkside X 12 V TEAM se-
ries. Batteries of the Parkside X 12 V TEAM
series may only be charged using chargers
of the Parkside X 12 V TEAM series.
We recommend that you operate this appli-
ance with the following batteries only:
PAPK 12 A3, PAPK 12 B3, PAPK 12 D1
GB MT
25