Beko GN1416240XBRN Manuel D'utilisation page 5

Important instructions regarding safety and environment
If the power the cord is damaged, it
shall be replaced by authorized service
only to avoid any risk that may occur.
Do not tuck the power cord under the
product or to the rear of the product. Do
not put heavy items on the power cord.
The power cord should not be bent,
crushed, and come into contact with
any heat source.
Do not use an extension cord, multi-
plug or adaptor to operate your product.
Portable multi sockets or portable
power supplies may overheat and cause
fire. Thus, do not have a multi-plug
behind or in the vicinity of the product.
The plug shall be easily accessible. If
this is not possible, a mechanism that
meets the electrical legislation and
that disconnects all terminals from
the mains (fuse, switch, main switch,
etc.) shall be available on the electrical
installation.
Do not touch the plug with wet hands.
When unplugging the appliance, don't
hold the power cord, but the plug.
Do not locate multiple portable socket-
outlets or portable power supplies at
the rear of the appliance.
1.4 Handling Safety
This product is heavy, do not handle it
by yourself.
Do not hold the product from its door
while handling the product.
Be careful not to damage the cooling
system and the pipes while handling
the product. Do not operate the product
if the pipes are damaged, and contact
an authorized service.
1.5 Installation Safety
Contact the Authorized Service for
the product's installation. To prepare
the product for installation, see the
information in the user guide and
make sure the electric and water
utilities are as required. If the
installation is not suitable, call a
qualified electrician and plumber
to have them make the necessary
arrangements. Otherwise, electric
shock, fire, issues with the product
or injuries may occur.
Check for any damage on the
product before installing it. Do not
have the product installed if it is
damaged.
Place the product on a level and
hard surface and balance with the
adjustable legs. Otherwise, the
refrigerator may tip over and cause
injuries.
The product shall be installed in a
dry and ventilated environment.
Do not keep carpets, rugs or similar
floor covers under the product. This
may cause risk of fire as a result of
inadequate ventilation!
Do not block or cover ventilation
holes. Otherwise, power
consumption may be increased and
damage to your product may occur.
Do not connect the product to
supply systems such as solar power
supplies. Otherwise, damage to
your product may occur as a result
of the abrupt voltage fluctuations!
The more refrigerant a refrigerator
contains, the bigger its installation
room shall be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m3 of
volume is required for each 8 grams
of refrigerant. The amount of the
refrigerant available in your product
is specified in the Type Label.
The installation place of the
product shall not be exposed to
4 / 27 EN
Refrigerator / User Manual