Steba VTH 2 Hot & Cold Mode D'emploi page 13

Workplace
Important:
Never place this device on or next to hot surfaces (e.g. hot sto-
ves). Only use it on a even, stable and a heat resisting surface. It is
important that no inflammable items are near to the device. Do
not place the device on the edge of the table so that it cannot be
touched by children or fall down when touched.
∙
The appliance must not be used near showers, bathtubs,
sinks or swimming pools.
∙ The adjusting knobs should never be accessible to persons who
are in the shower or bathtub to prevent any touching with wet
hands.
Getting started
∙ The device only starts when it is placed on a flat, not high pile surface and thereby
the safety switch is pressed.
∙ Connect the device, a signal sounds and the LED lights up
∙ Press the ON / OFF button to start the device. The last setting is displayed.
∙ The desired setting can be selected with the program button
∙ Fan:
o low speed level
o high speed level
∙ Heater:
o heating power 1200 Watt
o heating power 2000 Watt
o The pre-set temperature 18°C lights up.
∙ By pressing the temperature button
3 ° C between 18 ° C and 30 ° C.
∙ When the desired room temperature is reached, the device switches off and the set
value flashes. If the temperature drops again, the device switches on again.
∙ Note: the air output cannot be changed in heating mode.
∙ When finished, press the ON / OFF button. The ventilation continues to run for
approx. 15 seconds. Then pull out the plug.
, the temperature can be selected in steps of
13