Télécharger Imprimer la page

Steba VTH 2 Hot & Cold Mode D'emploi page 12

Publicité

Les langues disponibles
  • FR

Les langues disponibles

o bed and breakfast type environments.
∙ Before initial use: Heat up the device for about 15 min. to
eliminate the smell of newness.
Attention! Device gets hot. Risk of Burns! Parts of
this product may be very hot during operation. The air
outlet gets hot during operation. Special attention is
needed when children or vulnerable persons are present.
Do not blow on people or animals directly. Do not use the
device in small rooms if there are people or animals who
are unable to leave the room.
∙ If an extension cable is used, it has to have a cross-section of
1,5mm². A cable drum must always be unwound.
∙ If a GS-tested 16 A multi-pin extension is used, it may not be
charged with more then 3680 watts due to fire hazard.
∙ Make sure that children do not tease the cable or that a trip
hazard occurs.
∙ The device must always be disconnected from the power supply
if it is not supervised and before assembling, disassembling or
cleaning.
∙ Do not use the heater in rooms with explosive gas or while
using inflammable solvents or varnish or glues.
Cleaning
Attention! Pull the plug before cleaning.
∙ Never immerse the unit into water.
∙ We recommend to clean at least twice a year the air inlet and
air outlet with a vacuum cleaner to remove dust from motor
and heating element.
12

Publicité

loading