• Select a location with a surface
that is as stable and level as pos-
sible.
• Never try to force the pegs into
the ground! Lengthen the ancho-
ring of the guy lines if necessary
with the aid of a loop and place
the peg in a different location.
• Check regularly that all connec-
tion points remain intact and that
the pegs are firmly anchored.
• Do not remove any stitched-on
labels, name tags, or information
tags.
• WARNING! Do not use as a tent
for camping!
• WARNING! The product is made
of flammable material. Do not use
open flames inside or near the
beach shelter!
• WARNING! The beach shelter
may not be completely closed
while people are inside.
• When the product is set up be
careful not to stumble over the guy
lines.
• Check the product for damage
or wear before each use. The
product may be used only when
in good working order and
condition.
Pay attention to the weather
conditions
• Take the product down if the wind
picks up or if there are other ad-
verse weather conditions.
22
GB
• Do not make the set-up of the
beach shelter too taut since it may
then not be able to adapt to any
changing weather conditions and
can get damaged.
• Zips are wear parts and are not
covered by the terms of the war-
ranty.
• Do not use any insect spray in or
on the beach shelter.
• Any small leaks at the seams can
be sealed with a spray sealant.
• An impregnation spray can be
used for the tent fabric.
Assembly
Note: Set the product up with the
opening away from the prevailing
wind direction.
Warning: Make sure that the
frame is taut and always pops up
into the product's natural shape. En-
sure that the product does not cause
any injury when tensed.
1. Take the product (1) out of the
carrying bag (4) and lay it out
flat on the ground.
2. Loosen the rubber band around
the product.
3. The product pops up by itself into
its initial position.
4. Insert the pegs (3) into the loops
around the product and into the
loops at the ends of the guy lines
(2) and drive the pegs firmly into
the ground.