Powerfix Profi PDS 30 A1 Mode D'emploi Et Consignes De Sécurité page 16

Usage
♦ Loosen the locking screw
♦ If necessary, press the two locking bolts
pull the lower bar
is located under the load to be supported (Fig. C).
♦ Allow the two locking bolts
Use the red line which marks the position of the locking bolts
on the lower bar
♦ If the length of the lower bar
upwards (Fig. E) and pull the upper bar
♦ Re-tighten the locking screw
♦ To make fine adjustments to the height, press the pump lever
until the rubber pad
(Fig. G).
♦ To loosen and remove the prop, press the locking lever
upper bar
♦ Loosen the locking screw
♦ Hold the tube
out of their detent (Fig. B).
♦ Push the lower bar
A
C
PDS 30 A1
(Fig. A).
5
out up to the required height until the rubber pad
4
to engage completely in the tube
7
as an orientation aid.
4
is insufficient, push the locking lever
4
(Fig. F).
5
is located firmly under the load to be supported
1
has been completely retracted (Fig. H).
2
(Fig. A).
5
firmly with one hand and press the engaged locking bolts
6
back inside completely.
4
out of their detent (Fig. B) and
7
out to the required height.
2
3
upwards until the
8
B
D
GB │ IE
1
detent.
6
(Fig. D)
7
8
several times
7
│ 13 ■