Powerfix Profi PDS 30 A1 Mode D'emploi Et Consignes De Sécurité page 14

Safety instructions
CAUTION! RISK OF INJURY!
Check the prop before every use to make sure it is
►
in perfect condition. If you notice any damage you
may no longer use the prop.
Only use the prop for short-term erection and not for
►
permanent propping of ceilings, beams etc.
Ensure that the prop locking screw is always tightly
►
fastened when under load and that both locking
bolts are completely engaged.
Only use the prop on clean, non-slip and level
►
ground and in a stable position.
Please note that the prop or the supporting material
►
can be damaged by high pressure.
Never place more than 30 kg payload on the prop
►
at an inclination of 90°. At a lower inclination, the
max. load of the prop is lowered significantly.
Use the prop only at an inclination between 65°
►
and 90°.
Check the prop before every use to make sure it is in
►
perfect technical condition.
Never remain under supported loads.
►
Never use the prop for purposes other than those
►
described in these instructions.
PDS 30 A1 GB │ IE │ 11 ■