Oki Metcal BVX-200 Guide De L'utilisateur page 8

3.0 Technical Data
Max. airflow, free blowing.....................................250m3/h (150cfm)
Flow rate...............................................................2 x 75 m3/h (45cfm)
Static pressure......................................................850 Pa (3.5"WC)
Noise level (approx.) ............................................< 55dBA
Voltage .................................................................100 – 240 VAC, 1 phase
Frequency.............................................................50-60 Hz
Motor rating ..........................................................85 Watts
Safety compliance ................................................UL, CSA, CE
Dimensions W/D/Hmm .........................................508 x 254 x 388
Dimensions W/D/H in. ..........................................20" x 10" x 15.3"
Weight (approx.) ...................................................20 lbs. / 9 kg
4.0 Installation
Remove Metcal Fume Extraction System from packing materials and place on
the floor under workbench or near your work area where fume extraction is
required. Make sure you have access to the unit for filter maintenance.
Connect the unit power cord into the outlet on the side of the system. Plug the
power cord into a grounded wall socket.
Warning!
To provide protection against the risk of electrical shock, connect to properly
grounded outlets only.
Connect the unit to exhaust arms (optional) per installation instructions.
To power up system, depress the power switch, located on the bottom right of
the unit. (Red indicates "Power On" position) Operator can expect a delay of a
few seconds before hearing fan running. This is due to a built-in motor "Soft-
start feature".
Position the exhaust arms to optimize the fume capture.
Follow maintenance procedures below.
OK International ¥ Copyright © All Rights Reserved ¥ BVX-200 Rev 01-15-04
8