Publicité
Les langues disponibles
Les langues disponibles
installing your washer
step 2
Connecting the water supply and drain hoses
connecting the water supply hoses
Before installing the water supply hoses, make sure there are
rubber gaskets inside the fittings at both ends of each new
caution
water hose. Installing the water supply hoses without rubber
gaskets can cause water leakage.
When you initially install the washer, be sure to use new hoses.
Failing to do so may result in a water leakage or overflow and
caution
may damage your property.
Do not connect multiple water supply hoses together to
increase the length of the supply hose. Hoses connected this
caution
way can leak and the leakage can cause electrical shock. If a
hose is too short, replace the hose with a longer, high pressure
hose.
1. Connect the ends of the water supply hoses to the HOT and COLD faucets.
2. Tighten the fittings by hand until they are snug, and then tighten them an
additional two-thirds of a turn with a plier.
caution
3. Place the unconnected ends of the hoses into a bucket and open the
faucets connected to the two water supply hoses for 10 or 15 seconds to
remove any foreign substances from the hoses. Close the faucets before
continuing.
4. Connect the ends of the water supply hoses to the water supply intake
connections at the back of the washer.
caution
5. Tighten the fittings by hand until they are snug, and then tighten them
an additional two-thirds of a turn with a plier.
caution
6. Turn on the HOT and COLD water supplies and check all the water
supply intake connections and the faucets for water leaks.
WA3000J_WA40J3000AW_USER MANUAL_DC68-03520A-10.indd 14
When you fasten the fittings, do not fasten them too tightly or apply tape
or sealant to the faucets or water supply intakes. This can damage the
fittings.
After you have connected the water supply hoses to the faucets,
ensure that they are connected correctly by pulling the water supply
hoses downwards
The water supply hose connected to the HOT faucet must be
connected to the HOT water supply intake and the water hose
connected to the COLD faucet must be connected to the COLD
water supply intake.
To ensure correct water usage, connect both the HOT and COLD
water faucets. If either or both are not connected, the Tap cold
(no fill) LED will flash.
If you do not want to use the HOT water supply hose, insert
the water intake cap into the HOT water supply intake hole. In
this case, you must select the Tap Cold option for the water
temperature. If you select the Tap Cold option, all the lamps for
the water temperature options are turned off.
Confirm that the water supply hoses are not twisted or bent. If the
hoses are twisted or bent, the hoses can leak and cause electric
shock due to the water leakage.
English - 14
coupling
rubber washer
2016/6/27 19:11:14
Publicité
