Silverline 633524 Mode D'emploi page 9

Clearing jams
WARNING: Always disconnect the tool from the air supply before any adjustment or
maintenance is carried out.
Fastener jammed in magazine
1. Press the Magazine Latch (4) and slide the Magazine Cover (5) open.
2. Remove the obstruction using pliers.
3. Reload the magazine and close securely.
Fastener jammed in plate area
1. Undo the three Hex Screws (7) and remove the nose cover.
2. Remove the Safety Catch (6) and the pressure plate located underneath it.
3. Remove the obstruction using pliers.
4. Re-assemble and check the operation of the Safety Catch before using the tool.
Maintenance
WARNING: Always disconnect the machine from the air supply before carrying out any
maintenance or cleaning.
Note: Two Hex Keys (10) are provided with this air nailer that are suitable for partial disassembly
of this unit. These may be useful for cleaning, unjamming and replacing parts. Such disassembly is
not covered by this manual.
WARNING: Never use third party spares with this product. Only use spares supplied by
Silverline or an authorised Silverline stockist or repair centre.
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth.
IMPORTANT: There is very little that can go wrong with your air tool and it should be noted that
when an air tool fails to work it is generally because the internal workings have corroded due to
dirty, wet air and failure to follow the instructions given below.
Daily maintenance procedure
If an inline lubricator is not fitted to the air supply, the tool must be manually lubricated:
1. Disconnect from the air supply and remove any fasteners.
2. Pour 3-4 drops of oil into the air intake.
3. Reconnect the air supply and operate the machine several times to lubricate all internal
workings.
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL.
• Failure to comply with the operating and maintenance instructions may invalidate the guarantee.
Air Nailer Stapler 50mm
Storage
• Store this tool carefully in a secure, dry place out of the reach of children.
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222.
Web: www.silverlinetools.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
Hogeweg 39
5301 LJ Zaltbommel
The Netherlands
Disposal
• As with other power tools, air tools should not be disposed of with household waste.
• Air tools may contain traces of tool oil and other lubricants and so must be recycled accordingly.
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools.
silverlinetools.com
9