Publicité
Les langues disponibles
Les langues disponibles
DM 0500
SEMI-AUTOMTIC TYRE CHANGER 10"-21"
USE
Never use the machine before read this instruction and warning carefully.
1. Demounting the tyres:
Release all the air inside the tyre.
Remove the weight on the rim (Fig.3)
Place the tyre between the bead breaker blade (20) and rubber pad, and place
the blade on the bead 2 cm from the rim, step on the pedal (10) to separate the
bead from the rim. (Fig. 4)
The wenthole on the tyre should not near to the bead breaker blade during the
operation.
Note: This machine is designed particularly for the low pro le, stiff and wide
tyres, so there is a adjusting handle on the bead breaker.
When mount or demount the particular wide tyres, the operator can adjust the
handle position and do the operation on the wide tyres.(Fig. 5)
Turn round the tyre and repeat the above steps on the other parts of the tyre to get
it separate thoroughly from the rim.
The positioning scale on the turntable show the position of the rim directly (Fig. 6).
Place the tyre on the turntable after choosing the locking method.
Normally when working for aluminum alloy rim, outside locking is suitable, inside locking is seldom used.
(Fig. 7 and Fig. 8)
2. Inside locking
Pressing the pedal (9) make the 4-clamps closed to the position in accordance with the rim, then put the tyre on the
turntable, release the pedal (9) (release lightly), till the rim locked well.
Press the pedal (8) to turn the turntable (6), dip the prepared lubricator with the brush and then lubricate the bead
while turning,it is easy to damage the bead if do not follow the above instructions.
Move the vertical arm in the working position, make the mount/demount head close to the bead, the distance
between the mounting head and the rim should be 4-5mm.(Fig. 11), then lock the arm by press the locking button.
Publicité
